--- a
+++ b/Tools/AnyMocap/Description.any
@@ -0,0 +1,67 @@
+// ****************************
+// GENERAL DESCRIPTION OF MODEL
+// ****************************
+
+// This model uses motion capture C3D files to apply a motion th Full Body, or only to the Lower Extremities and trunk.
+// The model requires to run in two sequences and  can be switched in and out by switches in the top of the main 
+// file. The sequence  "MotionAndParameterOptimizationModel" is used for optimizing the motion and identifying model 
+// parameters such as segment lengths and local marker positions. The output from this analysis is  a set of parameters
+// and joints angles which is automatically saved. This model has no muscles. 
+// The second sequence is the inverse dynamics study which is driven by the optimized motion from 
+// the first study, this "InverseDynamicModel" model includes muscles.
+
+// Using the FullBody slows down the model and computational time increases a lot. It is thereofre recommended to 
+// use the LowerExtremity model if you are interested mostly in the leg.
+
+// ****************************
+// How to run the model
+// ****************************
+// 1. Run the MotionAndParameterOptimization sequence  first.
+// 2. Switch to the Inverse Dynamcis Sequence
+// 3. Reload the model (Press F7)
+// 4. Run the InverseDynamicAnalysis Sequence
+
+//***************************************************************************************************
+//If you intend to run your own set of C3D files, pleae have a look at the wiki on www.anyscript.org!
+//***************************************************************************************************
+
+
+
+// **************************************************
+//DESCRIPTIONS OF THE INDIVIDUAL STUDIES IN THE MODEL
+// **************************************************
+//KinematicStudyForParameterIdentification: 
+//    This study is the basis study for the Parameter identification study
+//
+//ParameterIdentification:
+//    Running this study will optimize the parameters of the model: segments length and marker positions
+//    It will also calculate the motion but usually this optimization is done with a lower amount of 
+//    timesteps so the produced motion is not usefull for an inverse dynamic analysis. The reduced 
+//    number of timesteps will speed the optimization it should however not be too low, this will
+//    reduce the accuracy
+//    
+//MotionOptimization:
+//    This study will run the kinematic analysis using the optimize parameters from the ParameterIdentification study 
+//    This study will run with a high number of timesteps. It will automatically save the optimized motion in files 
+//    named according to name of the used C3D which is specified in the ModelSetup.any file
+//
+//LoadParametersOptimizationResults 
+//    This study is used ONLY for loading the optimized results from the ParameterIdentification study
+//
+//InverseDynamicStudy:
+//    This study run the inverse dynamic analysis of the model with the optimized motion and optimized parameters
+//
+//
+//The studies has to to be activated in a certain sequence, to make this easier there are the following
+//operation sequences:
+//
+//MotionAndParameterOptimiztionSequence: 
+//    This seqeunce is used for determining the model parameters such as segment lenghts, marker positions
+//    
+//
+//InverseDynamicAnalysisSequence:
+//    This study sequence is used for calibrating the model and running the inverse dynamic analysis 
+
+
+
+