--- a
+++ b/Application/Examples/KneeSimulator/UserDefinedSettings.any
@@ -0,0 +1,60 @@
+// Define prefix for output data
+#define OutputFileNamePrefix "Setting_1"
+
+// Set SAVE_H5 to 1 in order to save the output of the study to an h5 file in the Output folder, 0:Off
+#define SAVE_H5 0
+
+//Define to use FDK (0: off 1: on)
+#ifndef USE_FDK
+#define USE_FDK 1 
+#endif
+
+#ifndef USE_LIGAMENT_CALIBRATION
+#define USE_LIGAMENT_CALIBRATION 1
+#endif
+//Contact pressure adopted from Marra et al 2015 DOI:10.1115/1.4029258 "This value provided a good trade-off between the amount of 
+//penetration obtained and the numerical issues involved in solving contact between two surfaces with high stiffness" pg 6.
+#ifndef DEF_CONTACT_PRESSURE_TIBIOFEMORAL
+#define DEF_CONTACT_PRESSURE_TIBIOFEMORAL 9.3e9*5
+#endif
+
+#ifndef DEF_CONTACT_PRESSURE_PATELLOFEMORAL
+#define DEF_CONTACT_PRESSURE_PATELLOFEMORAL 9.3e9*5
+#endif
+
+//Trial Specific Settings used in AnyOprSetForceDepKin (see manual for more information) 
+#ifndef FDK_ForceTol
+#define FDK_ForceTol 1e-4
+#endif
+
+#ifndef FDK_MaxNewtonStep
+#define FDK_MaxNewtonStep 1e-2
+#endif
+
+#ifndef FDK_MaxIteration
+#define FDK_MaxIteration 100
+#endif
+
+//Min&Max knee flexion the simulator is driven
+#ifndef DEF_KNEE_FLEXION_MIN
+#define DEF_KNEE_FLEXION_MIN 10
+#endif
+
+#ifndef DEF_KNEE_FLEXION_MAX
+#define DEF_KNEE_FLEXION_MAX 60
+#endif
+
+//Min&Max axial hip loads applied to simulator
+#ifndef DEF_HIP_AXIAL_LOAD_MIN
+#define DEF_HIP_AXIAL_LOAD_MIN 200
+#endif
+
+#ifndef DEF_HIP_AXIAL_LOAD_MAX
+#define DEF_HIP_AXIAL_LOAD_MAX 200
+#endif
+
+//Specimen-Specific Settings
+#define FEMUR_MASS_RATIO 0.135
+#define TIBIA_MASS_RATIO 0.0465
+
+#include "Input/Ligament_Properties.any"
\ No newline at end of file